IS 350 V6-3.5L (2GR-FSE) (2006)
/Page-1507009.png)
d) Using a brass bar and a hammer, stake the 2 claw washers.
NOTICE: Avoid any impact to the steering rack.
2. INSTALL NO.1 STEERING RACK BOOT
a) Apply lithium soap base glycol grease to the inside of the small opening of the No.1 steering rack boot (LH side).
b) Temporarily install a new No.1 steering rack boot clamp to the large opening of the No.1 steering rack boot (LH side) at the position shown by
arrow (A).
NOTICE:
^
Use a new No.1 steering rack boot clamp.
^
Do not expand the No.1 steering rack boot clamp more than necessary for installation.
^
Do not deform the No.1 steering rack boot clamp.
^
Tightening force of the No.1 steering rack boot clamp becomes uneven if it is installed after being expanded as shown in the illustration.
As a result, rust is caused by water entering from the clearance between the No.1 steering rack boot and rack housing, causing a
malfunction.
^
Use only the supply parts which are applicable to the vehicle to secure the No.1 steering rack boot.
HINT: After disengaging the claw of a new No.1 steering rack boot clamp, temporarily install it from the end without expanding the clamp
diameter more than necessary.
c) Install the No.1 rack boot (LH side) to the groove on the rack housing.
NOTICE:
