IS 350 V6-3.5L (2GR-FSE) (2006)
d) Cover the adjusting nut with the dust boot.
NOTICE: The directions of the intermediate shaft companion flange and the propeller shaft companion flange should differ by 180°.
e) Temporarily tighten the adjusting nut by hand.
INSTALLATION
1. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY
a) Apply grease to the flexible coupling centering bushings.
Grease: Molybdenum disulphide lithium base NLGI No.2
b) Align the matchmarks on the transmission companion flange and flexible coupling.
c) Install and tighten the 3 bolts, 3 washers and 3 nuts.
Torque: 79 Nm (805 kgf-cm, 58 ft. lbs.)
NOTICE: Be careful not to damage the flexible coupling centering bushing.
HINT: The bolts should be installed from the propeller shaft side.