IS F V8-5.0L (2UR-GSE) (2008)
Central Control Module: Service and Repair
Removal
NETWORKING: NETWORK GATEWAY ECU: REMOVAL
NETWORKING: NETWORK GATEWAY ECU: REMOVAL
NOTICE:
When disassembling the network gateway ECU, eliminate static electricity by touching the vehicle body to prevent the components from being damaged.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment See: Restraint Systems/Air Bag
Systems/Service Precautions.
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
2. REMOVE FRONT DOOR SCUFF PLATE
HINT: Removal procedure of the RH side is the same as that of the LH side See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal.
3. REMOVE FRONT DOOR OPENING TRIM COVER
HINT: Removal procedure of the RH side is the same as that of the LH side See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal.
4. REMOVE SIDE INSTRUMENT PANEL See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal
5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal
6. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY See: Restraint Systems/Air Bag Systems/Air Bag/Service and
Repair/Front Passenger Side Knee Airbag Assembly/Removal
7. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal
8. REMOVE NETWORK GATEWAY ECU
(a) Disconnect the connector.
(b) Disengage the 2 claws and remove the cover.