IS F V8-5.0L (2UR-GSE) (2008)
(c) Using SST, install the rear suspension member rear body mounting cushion until there is no clearance between the suspension member
sub-assembly and rear suspension member rear body mounting cushion.
SST: 09570-24011
SST: 09950-40011
09951-04020
09952-04010
09953-04030
09954-04020
09955-04061
09957-04010
09958-04011
SST: 09950-60020
09951-00910
NOTICE:
-
Apply a small amount of grease to the threads of SST (center bolt) before use.
-
Do not apply excessive pressure to the center sleeve of the rear suspension member rear body mounting cushion.
5. INSTALL REAR SUSPENSION MEMBER REAR BODY MOUNTING CUSHION (for RH Side)
HINT: Perform the same procedure as the LH side.
6. INSTALL REAR SUSPENSION MEMBER FRONT BODY MOUNTING CUSHION (for LH Side)
(a) Apply diluted liquid soap to the outside of a new rear suspension member front body mounting cushion.
NOTICE: Do not use grease or undiluted liquid soap. Doing so may cause the rear suspension member body mounting cushion to slip out.
HINT: A 20% liquid hand soap and water concentration is recommended.
(b) Temporarily install the rear suspension member front body mounting cushion while confirming the installation direction.