IS F V8-5.0L (2UR-GSE) (2008)
(c) Fully tighten the 8 bolts.
Bolt A - Torque: 127 Nm (1300 kgf-cm, 94 ft-lbf)
Bolt B - Torque: 19 Nm (195 kgf-cm, 14 ft-lbf)
11. INSTALL REAR SUSPENSION REAR LOWER MEMBER BRACE LH
(a) Install the rear suspension rear lower member brace LH with the 4 bolts.
Torque: 19 Nm (195 kgf-cm, 14 ft-lbf)
12. INSTALL REAR SUSPENSION REAR LOWER MEMBER BRACE RH
HINT: Perform the same procedure as the LH side.
13. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY See: Transmission and Drivetrain/Differential Assembly/Differential Carrier/Service
and Repair/Removal and Replacement/Installation
14. INSTALL HOLE SNAP RING (for LH Side) See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service
and Repair/Installation
15. INSTALL HOLE SNAP RING (for RH Side)
HINT: Perform the same procedure as the LH side.
16. INSTALL REAR DRIVE SHAFT ASSEMBLY LH See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Installation
17. INSTALL REAR DRIVE SHAFT ASSEMBLY RH
HINT: Perform the same procedure as the LH side.
18. INSTALL REAR STABILIZER BAR See: Steering and Suspension/Suspension/Stabilizer Bar/Service and Repair/Rear Stabilizer Bar/Installation