IS F V8-5.0L (2UR-GSE) (2008)
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR: REMOVAL
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR: REMOVAL
HINT:
-
Use the same procedure for the RH side and LH side.
-
The procedure listed below is for the LH side.
-
If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.
1. REMOVE REAR WHEEL
2. REMOVE REAR SPEED SENSOR WIRE
(a) Using a screwdriver, disconnect the rear speed sensor wire.
3. REMOVE REAR SPEED SENSOR
(a) Remove the bolt and rear speed sensor.
NOTICE: Prevent foreign matter from attaching to the sensor tip.
Installation
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR: INSTALLATION
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR: INSTALLATION
1. INSTALL REAR SPEED SENSOR