IS F V8-5.0L (2UR-GSE) (2008)
(e) Connect the engine wire clamp.
2. INSTALL CAMSHAFT TIMING CONTROL WITH EDU MOTOR RH ASSEMBLY
(a) Turn the camshaft timing gear assembly intermediate shaft index slot in the counterclockwise direction by hand, to set it to the maximum retard
angle position.
HINT:
-
When a camshaft lobe opens a valve, the intermediate shaft becomes difficult to turn.
-
The position where the intermediate shaft stops is the maximum retard angle.
(b) Install a new O-ring to the timing chain cover.
(c) Align the joint of the camshaft timing control with EDU motor and the keyway of the camshaft timing gear assembly, and install the motor
with the 3 bolts.
Torque: 21 Nm (214 kgf-cm, 15 ft-lbf)
NOTICE:
-
Check that [R] is printed on the label of the camshaft timing control with EDU motor.
-
Do not allow foreign matter to contact the oil seal face of the camshaft timing control with EDU motor (the surface that contacts the timing
chain cover sub-assembly).
-
When installing the camshaft timing control with EDU motor, do not use excessive force.
-
Align the timing chain cover sub-assembly knock pin with the camshaft timing control with EDU motor pin hole to install the camshaft
timing control with EDU motor.
-
Install the camshaft timing control with EDU motor with the arrow facing upward, as shown in the illustration.
-
Do not drop the camshaft timing control with EDU motor. If dropped, replace it.
-
Do not disassemble the camshaft timing control with EDU motor assembly. If disassembled, replace it.