IS F V8-5.0L (2UR-GSE) (2008)
Variable Valve Timing Actuator: Testing and Inspection
Camshaft Oil Control Valve
Inspection
2UR-GSE ENGINE CONTROL: CAMSHAFT OIL CONTROL VALVE: INSPECTION
2UR-GSE ENGINE CONTROL: CAMSHAFT OIL CONTROL VALVE: INSPECTION
1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
If the result is not as specified, replace the oil control valve.
(b) Connect a battery positive (+) lead to terminal 1 and negative (-) lead to terminal 2, and check the movement of the valve.
OK:
If the result is not as specified, replace the oil control valve.
NOTICE: Do not allow foreign matter to contact the oil seal face of the oil control valve (the surface that contacts the cylinder head cover
sub-assembly).
HINT: If the valve cannot return properly because of foreign matter, a small pressure leak in the advance direction may occur and a DTC may
be stored.
On-Vehicle Inspection
2UR-GSE ENGINE CONTROL: CAMSHAFT OIL CONTROL VALVE: ON-VEHICLE INSPECTION