IS F V8-5.0L (2UR-GSE) (2008)
(c) Install the No. 7 engine room relay block with the 2 bolts and nut.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
4. INSTALL BATTERY TRAY
(a) Install the battery tray with the 3 bolts.
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
5. INSTALL POWER STEERING ECU ASSEMBLY See: Relays and Modules/Relays and Modules - Steering and Suspension/Relays and Modules
- Steering/Steering Control Module/Service and Repair/Power Steering ECU/Installation
6. INSTALL NO. 1 BATTERY TRAY SUPPORT
7. INSTALL BATTERY
(a) Install the battery.
(b) Install the battery insulator.
(c) Install the battery clamp with a nut.
Torque: 2.9 Nm (30 kgf-cm, 26 in-lbf)
(d) Connect the cable to the positive (+) battery terminal.
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
(e) Connect the 2clamps.
8. INSTALL AIR CLEANER CAP SUB-ASSEMBLY See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Installation
9. INSTALL ENGINE ROOM SIDE COVER LH See: Service and Repair/Removal and Replacement/Engine Assembly/Installation
10. INSTALL ENGINE ROOM SIDE COVER RH See: Service and Repair/Removal and Replacement/Engine Assembly/Installation
11. INSTALL COOL AIR INTAKE DUCT SEAL See: Service and Repair/Removal and Replacement/Engine Assembly/Installation
12. INSTALL V-BANK COVER SUB-ASSEMBLY See: Service and Repair/Removal and Replacement/Engine Assembly/Installation