IS F V8-5.0L (2UR-GSE) (2008)
Water Pump: Service and Repair
Installation
2UR-GSE COOLING: WATER PUMP: INSTALLATION
1. INSTALL WATER PUMP
(a) Install the water pump and a new gasket with the 9 bolts as shown in the illustration.
A Torque: 20 Nm (204 kgf-cm, 15 ft-lbf)
B Torque: 23 Nm (235 kgf-cm, 17 ft-lbf)
C Torque: 47 Nm (479 kgf-cm, 35 ft-lbf)
2. INSTALL WATER PUMP PULLEY
(a) Temporarily install the pulley with the 4 bolts.
(b) Using a screwdriver or an equivalent, hold the pulley and tighten the 4 bolts.
Torque: 21 Nm (214 kgf-cm, 15 ft-lbf)
HINT: Tape the screwdriver tip before use to avoid damage.
3. INSTALL WATER INLET HOUSING
(a) Install a new gasket to the water pump.
(b) Install the water inlet housing with the 3 bolts.
Torque: 21 Nm (214 kgf-cm, 15 ft-lbf)
4. CONNECT NO. 3 WATER BY-PASS HOSE