IS F V8-5.0L (2UR-GSE) (2008)
(a) Start the engine.
Result:
HINT: *: The tester cannot communicate with the ECM.
B -- GO TO VC OUTPUT CIRCUIT
A -- Continue to next step.
6. CHECK HARNESS AND CONNECTOR (ECM TERMINAL VOLTAGE)
(a) Disconnect the ECM connector.
(b) Turn the engine switch on (IG).
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
(d) Reconnect the ECM connector.
NG -- CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM)
OK -- REPLACE ECM
7. CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM)