IS F V8-5.0L (2UR-GSE) (2008)
EXAMPLE:
If the existing shim (installed shim) is 2.300 mm (0.0906 in.), and the measured clearance is 0.39 mm (0.0154 in.), then a new 2.520 mm
(0.0992 in.) No. 52 shim should be used as a replacement for the existing shim.
New Shim Thickness mm (in.)
(f) Install the camshaft See: Engine, Cooling and Exhaust/Engine/Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Installation.
(g) Install the chain sub-assembly See: Engine, Cooling and Exhaust/Engine/Service and Repair/Overhaul/Reassembly.
(1) Install the chain sub-assembly (for Bank 2).
(2) Install the No. 1 chain vibration damper (for Bank 2).
(3) Install the chain tensioner slipper (for Bank 2).
(4) Install the No. 1 chain tensioner assembly (for Bank 2).
(5) Install the chain sub-assembly (for Bank 1).
(6) Install the No. 1 chain vibration damper (for Bank 1).
(7) Install the chain tensioner slipper (for Bank 1).
(8) Install the No. 1 chain tensioner assembly (for Bank 1).
(9) Tighten the camshaft timing gear assembly.
(h) Inspect the valve clearance again.
NOTICE: Be sure to inspect the valve clearance with the chain cub-assembly installed. When rotating the camshaft without the chain
sub-assembly installed, contact between the valves and pistons may occur.
HINT: If the valve clearance is not as specified, readjust the valve clearance.
12. INSTALL OIL REFLECTOR PLATE LH (for Bank 1) See: Engine, Cooling and Exhaust/Engine/Service and Repair/Overhaul/Reassembly
13. INSTALL OIL REFLECTOR PLATE RH (for Bank 2) See: Engine, Cooling and Exhaust/Engine/Service and Repair/Overhaul/Reassembly
14. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY LH (for Bank 1) See: Engine, Cooling and Exhaust/Engine/Service and
Repair/Overhaul/Reassembly
15. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY (for Bank 2) See: Engine, Cooling and Exhaust/Engine/Service and
Repair/Overhaul/Reassembly
16. INSTALL IGNITION COIL ASSEMBLY See: Powertrain Management/Ignition System/Ignition Coil/Service and Repair/Installation
17. CONNECT WIRE HARNESS See: Engine, Cooling and Exhaust/Engine/Engine Lubrication/Oil Pump/Service and Repair/Oil Pump/Installation
18. INSTALL FUEL PUMP ASSEMBLY (for Bank 1) See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Pump/Service and
Repair/Fuel Pump (For High Pressure)/Installation
19. INSTALL FUEL PUMP ASSEMBLY (for Bank 2) See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Pump/Service and
Repair/Fuel Pump (For High Pressure)/Installation