IS F V8-5.0L (2UR-GSE) (2008)
(b) Remove the 2 nuts and ECM from the ECM box.
Installation
2UR-GSE ENGINE CONTROL: ECM: INSTALLATION
2UR-GSE ENGINE CONTROL: ECM: INSTALLATION
1. INSTALL ECM
(a) Install the ECM to the engine room ECU box with the 2 nuts.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
NOTICE:
-
Install the ECM on the ECM box with the label facing away from the engine.
-
Make sure that there is no foreign matter on the gasket surface of the ECM box.
-
Insert the stud bolt on the vehicle rear side to the ECM first.
-
Make sure that the stud bolts are securely installed into the front and rear bolt holes.
(b) Connect the 6 ECM connectors.
NOTICE: Be sure to securely connect the connector.
(c) Connect the connector holder.
2. INSTALL ENGINE ROOM ECU COVER