IS F V8-5.0L (2UR-GSE) (2008)
/Page-1067016.png)
(a) Disconnect the ECM main bus line connector (J2) from the CAN LH junction connector A side (w/ earth terminal).
NOTICE:
-
Before disconnecting the connector, make a note of where it is connected.
-
Reconnect the connector to its original position.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
HINT: Measure the resistance with the gateway ECU main bus line connector (J84) disconnected.
Result:
B -- RECONNECT CONNECTOR
A -- Continue to next step.
6. CHECK CAN LH JUNCTION CONNECTOR
