IS F V8-5.0L (2UR-GSE) (2008)
/Page-1068012.png)
(b) Measure the voltage and resistance according to the value(s) in the table below.
If the result is not as specified, there may be a malfunction on the wire harness side.
4. CHECK MULTIPLEX TILT AND TELESCOPIC ECU
(a) Disconnect the multiplex tilt and telescopic ECU connector.
(b) Measure the voltage and resistance according to the value(s) in the table below.
If the result is not as specified, there may be a malfunction on the wire harness side.
5. CHECK MULTIPLEX NETWORK MASTER SWITCH
(a) Disconnect the multiplex network master switch connector.
(b) Measure the voltage and resistance according to the value(s) in the table below.
