IS F V8-5.0L (2UR-GSE) (2008)
Secondary Injector Control Module: Service and Repair
Removal
2UR-GSE FUEL: INJECTOR DRIVER: REMOVAL
2UR-GSE FUEL: INJECTOR DRIVER: REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
2. REMOVE V-BANK COVER SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
3. REMOVE INJECTOR DRIVER
(a) Disconnect the 8 injector driver connectors.
(1) Disconnect the 6 connectors with wire harness locks and the 2 connectors without wire harness locks from the 2 injector drivers.
HINT: To release each connector lock, push the claw downward ("Release" in the illustration) and move the lock lever ("Move" in the
illustration).
(b) Remove the 8 nuts and 2 injector drivers from the intake air surge tank assembly.
NOTICE: Be careful not to drop or strike the injector drivers.