IS F V8-5.0L (2UR-GSE) (2008)
Standard Voltage:
(g) While turning the crankshaft pulley by hand, measure the voltage between each terminal. Check that the voltage changes between the Hi range
and Lo range shown in the table below.
Standard Voltage:
2. CHECK VVT SENSOR OUTPUT VOLTAGE
(a) Remove the V-bank cover sub-assembly See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal.
(b) Disconnect the 2 fuel delivery pipe connectors.
(c) Disconnect the 4 connectors with wire harness locks from the 2 injector drivers.