IS F V8-5.0L (2UR-GSE) (2008)
Camshaft Position Sensor: Testing and Inspection
2UR-GSE ENGINE CONTROL: CAMSHAFT POSITION SENSOR: ON-VEHICLE INSPECTION
2UR-GSE ENGINE CONTROL: CAMSHAFT POSITION SENSOR: ON-VEHICLE INSPECTION
1. CHECK CAMSHAFT POSITION SENSOR OUTPUT VOLTAGE
(a) Remove the V-bank cover sub-assembly See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal.
(b) Disconnect the 2 fuel delivery pipe connectors.
(c) Disconnect the 4 connectors with wire harness locks from the 2 injector drivers.
HINT:
-
To release each connector lock, push the claw downward ("Release" in the illustration) and move the lock lever ("Move" in the
illustration).
-
Perform this step to prevent the engine from starting.
(d) Remove the engine room ECU cover See: Computers and Control Systems/Engine Control Module/Service and Repair/Removal and
Replacement/Removal.
(e) Turn the engine switch on (IG).
HINT: Do not start the engine.
(f) Measure the voltage according to the value(s) in the table below.