IS F V8-5.0L (2UR-GSE) (2008)
Ignition Switch: Testing and Inspection
2UR-GSE STARTING: ENGINE SWITCH: INSPECTION
2UR-GSE STARTING: ENGINE SWITCH: INSPECTION
1. INSPECT ENGINE SWITCH
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
If the resistance is not as specified, replace the engine switch.
(b) Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.
HINT:
-
If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.
-
If the voltage is too low, the indicator will not illuminate.
OK:
If the result is not as specified, replace the engine switch.