IS F V8-5.0L (2UR-GSE) (2008)
/Page-2092002.png)
(3) Move SST at least 10 m (33 ft.) away from the vehicle front side window.
(4) Maintaining sufficient clearance for the SST wire harness in the front side window, close all doors and windows of the vehicle.
NOTICE: Take care not to damage the SST wire harness.
(5) Connect the red clip of SST to the positive (+) battery terminal and the black clip of SST to the negative (-) battery terminal.
(e) Deploy the airbag.
(1) Check that no one is inside the vehicle or within a 10 m (33 ft.) radius of the vehicle.
(2) Press the SST activation switch and deploy the airbag.
CAUTION:
-
When deploying the airbag, make sure that no one is near the vehicle.
-
The front seat side airbag assembly becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes
after deployment.
-
Use gloves and safety glasses when handling a front seat side airbag assembly with a deployed airbag.
-
Do not apply water, etc. to a front seat side airbag assembly with a deployed airbag.
-
Always wash your hands with water after completing the operation.
HINT: The airbag is deployed as the LED of the SST activation switch comes on.
3. DISPOSE OF FRONT SEAT SIDE AIRBAG ASSEMBLY (WHEN NOT INSTALLED IN VEHICLE)
NOTICE:
-
When disposing of the front seat side airbag assembly, never use the customer's vehicle to deploy the airbag.
-
Be sure to follow the following procedure when deploying the airbag.
HINT: Prepare a battery as the power source to deploy the airbag.
(a) Check the function of SST See: Steering Pad/Disposal.
(b) Remove the front seat side airbag assembly.
(1) Remove the front seat assembly See: Body and Frame/Seats/Service and Repair/Front Seat Assembly/Removal.
(2) Remove the 2 nuts and the front seat side airbag assembly from the seatback assembly See: Body and Frame/Seats/Service and
Repair/Front Seat Assembly/Disassembly.
CAUTION:
-
When removing the front seat side airbag assembly, work must be started at least 90 seconds after the engine switch is turned off
and the negative (-) battery terminal cable is disconnected from the battery.
-
When storing the front seat side airbag assembly, keep the airbag deployment side facing upward.
(c) Using braided wire, tie down the front seat side airbag assembly to an unneeded tire.
Wire:
