lexus Workshop Repair Guides

Lexus Workshop Service and Repair Manuals

Front Seat Cushion Assembly (w/ Occupant Classification ECU, Occupant Classification Sensor)|Page 7014 > < Front Seat Cushion Assembly (w/ Occupant Classification ECU, Occupant Classification Sensor)|Page 7012
Page 4
background image

HINT: To calculate the area of the stripped wire section:
Area = 3.14 x (Diameter)2 divided by 4
(1) Position the driver side knee airbag assembly inside the tire with the airbag deployment side facing inside.

Minimum tire size:
Must exceed the following dimensions
Width:
185 mm (7.28 in.)
Inner diameter:
360 mm (14.2 in.)

CAUTION:
-

Make sure that the wires are tight. If there is slack in the wires, the driver side knee airbag assembly may break loose due to the
shock when the airbag is deployed.

-

Always tie down the driver side knee airbag assembly with the airbag deployment side facing inside the tire as shown in the
illustration.

NOTICE: The tire will be marked by the airbag deployment, so use an unneeded tire.

(d) Install SST.

(1) Connect the SST connector to the driver side knee airbag assembly.

SST: 09082-00770

(e) Place the tires.

(1) Place at least 2 tires under the tire tied to the driver side knee airbag assembly.
(2) Place at least 2 tires onto the tire tied to the driver side knee airbag assembly. The top tire should have a wheel installed.
NOTICE: Do not place the SST connector under the tire because it could be damaged.

Front Seat Cushion Assembly (w/ Occupant Classification ECU, Occupant Classification Sensor)|Page 7014 > < Front Seat Cushion Assembly (w/ Occupant Classification ECU, Occupant Classification Sensor)|Page 7012