IS F V8-5.0L (2UR-GSE) (2008)
/Page-2094007.png)
(e) Disengage the 2 pins and separate the driver side knee airbag assembly.
(f) Disconnect the connector and remove the driver side knee airbag assembly.
NOTICE: When disconnecting the airbag connector, take care not to damage the airbag wire harness.
Installation
SUPPLEMENTAL RESTRAINT SYSTEMS: DRIVER SIDE KNEE AIRBAG ASSEMBLY: INSTALLATION
SUPPLEMENTAL RESTRAINT SYSTEMS: DRIVER SIDE KNEE AIRBAG ASSEMBLY: INSTALLATION
1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Connect the driver side knee airbag connector to the driver side knee airbag assembly.
NOTICE: When connecting the airbag connector, take care not to damage the airbag wire harness.
(d) Temporarily install the driver side knee airbag assembly with the 2 pins.
(e) Install the driver side knee airbag assembly with the 4 bolts.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
