IS F V8-5.0L (2UR-GSE) (2008)
(2) Connect the SST connector to the front seat side airbag assembly connector.
SST: 09082-00700
SST: 09082-00750
NOTICE: To avoid damaging the SST connector and wire harness, do not lock the secondary lock of the twin lock.
(3) Move SST at least 10 m (33 ft.) away from the vehicle front side window.
(4) Maintaining sufficient clearance for the SST wire harness in the front side window, close all doors and windows of the vehicle.
NOTICE: Take care not to damage the SST wire harness.
(5) Connect the red clip of SST to the positive (+) battery terminal and the black clip of SST to the negative (-) battery terminal.
(e) Deploy the airbag.
(1) Check that no one is inside the vehicle or within a 10 m (33 ft.) radius of the vehicle.
(2) Press the SST activation switch and deploy the airbag.
CAUTION:
-
When deploying the airbag, make sure that no one is near the vehicle.
-
The front seat side airbag assembly becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes
after deployment.
-
Use gloves and safety glasses when handling a front seat side airbag assembly with a deployed airbag.
-
Do not apply water, etc. to a front seat side airbag assembly with a deployed airbag.
-
Always wash your hands with water after completing the operation.
HINT: The airbag is deployed as the LED of the SST activation switch comes on.
3. DISPOSE OF FRONT SEAT SIDE AIRBAG ASSEMBLY (WHEN NOT INSTALLED IN VEHICLE)
NOTICE:
-
When disposing of the front seat side airbag assembly, never use the customer's vehicle to deploy the airbag.
-
Be sure to follow the following procedure when deploying the airbag.
HINT: Prepare a battery as the power source to deploy the airbag.
(a) Check the function of SST See: Steering Pad/Disposal.
(b) Remove the front seat side airbag assembly.
(1) Remove the front seat assembly See: Body and Frame/Seats/Service and Repair/Front Seat Assembly/Removal.
(2) Remove the 2 nuts and the front seat side airbag assembly from the seatback assembly See: Body and Frame/Seats/Service and
Repair/Front Seat Assembly/Disassembly.
CAUTION:
-
When removing the front seat side airbag assembly, work must be started at least 90 seconds after the engine switch is turned off
and the negative (-) battery terminal cable is disconnected from the battery.