IS F V8-5.0L (2UR-GSE) (2008)
Seat Occupant Classification Module - Air Bag: Service and Repair
Installation
SUPPLEMENTAL RESTRAINT SYSTEMS: OCCUPANT CLASSIFICATION ECU: INSTALLATION
SUPPLEMENTAL RESTRAINT SYSTEMS: OCCUPANT CLASSIFICATION ECU: INSTALLATION
1. INSTALL OCCUPANT CLASSIFICATION ECU
(a) Install the occupant classification ECU with the 2 nuts.
Torque: 3.0 Nm (31 kgf-cm, 27 in-lbf)
NOTICE:
-
If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the
occupant classification ECU with a new one.
-
When installing the occupant classification ECU, be careful that the SRS wiring does not interfere with other parts and that it is not
pinched between other parts.
-
Do not allow oil or grease to adhere to the occupant classification ECU during installation.
(b) Connect the connector.
NOTICE: When connecting the airbag connector, take care not to damage the airbag wire harness.
2. INSTALL FRONT SEAT ASSEMBLY RH
HINT: Use the same procedure for the RH side and the LH side See: Body and Frame/Seats/Service and Repair/Front Seat
Assembly/Installation.
3. INSTALL REAR INNER SEAT TRACK BRACKET COVER RH
HINT: Use the same procedure for the RH side and the LH side See: Body and Frame/Seats/Service and Repair/Front Seat
Assembly/Installation.
4. INSTALL REAR OUTER SEAT TRACK BRACKET COVER RH
HINT: Use the same procedure for the RH side and the LH side See: Body and Frame/Seats/Service and Repair/Front Seat
Assembly/Installation.
5. INSTALL FRONT INNER SEAT TRACK BRACKET COVER RH
HINT: Use the same procedure for the RH side and the LH side See: Body and Frame/Seats/Service and Repair/Front Seat
Assembly/Installation.
6. INSTALL FRONT OUTER SEAT TRACK BRACKET COVER RH
HINT: Use the same procedure for the RH side and the LH side See: Body and Frame/Seats/Service and Repair/Front Seat
Assembly/Installation.
7. INSTALL FRONT SEAT HEADREST ASSEMBLY RH
8. PERFORM REGISTRATION
(a) If the occupant classification ECU has been replaced, perform registration See: Testing and Inspection/Programming and
Relearning/Registration.
9. ZERO POINT CALIBRATION AND SENSITIVITY CHECK
(a) If the occupant classification ECU has been replaced, perform zero point calibration and sensitivity check See: Testing and
Inspection/Programming and Relearning/Initialization.
10. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.
11. INSPECT FRONT SEAT ASSEMBLY See: Body and Frame/Seats/Service and Repair/Front Seat Assembly/Installation