IS F V8-5.0L (2UR-GSE) (2008)
(d) Remove the 2 bolts and the front seat outer belt assembly.
Installation
SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: INSTALLATION
SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: INSTALLATION
1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY
(a) Check the degree of tilt when the ELR begins to lock.
(1) Check that the belt does not lock at less than 15 degrees of tilt in any direction but locks at over 45 degrees of tilt while gently pulling the
belt.
NOTICE: Do not disassemble the retractor.
2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY
(a) Temporarily install the front seat outer belt assembly with the 2 bolts.
(b) Fully tighten the upper side bolt first, then the lower side bolt to install the front seat outer belt assembly.
For upper bolt - Torque: 7.5 Nm (77 kgf-cm, 66 in-lbf)
For lower bolt - Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)
(c) Connect the pretensioner connector and lock the locking button as shown in the illustration.
NOTICE: Securely lock the locking button.
(d) Connect the connectors.