IS F V8-5.0L (2UR-GSE) (2008)
/Page-2185004.png)
SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT AIRBAG SENSOR: INSTALLATION
1. INSTALL FRONT AIRBAG SENSOR
(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Temporarily install the front airbag sensor with the 2 claws and pin.
(d) Install the front airbag sensor with the 2 bolts.
Torque: 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTICE:
-
If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new
one.
-
When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between
other parts.
-
Make sure that the pin is securely inserted into the body hole.
-
Tighten the bolt while holding the front airbag sensor because the front airbag sensor claws and pin (stopper) are easily damaged.
(e) Connect the connector to the front airbag sensor.
NOTICE: When connecting the airbag connector, take care not to damage the airbag wire harness.
(f) Check that there is no looseness in the installation parts of the front airbag sensor.
2. INSTALL HEADLIGHT ASSEMBLY See: Lighting and Horns/Headlamp/Service and Repair/Removal and Replacement/Installation
3. INSTALL FRONT UPPER FENDER PROTECTOR LH (for LH Side) See: Wiper and Washer Systems/Wiper Motor/Service and
Repair/Installation
4. INSTALL ENGINE ROOM SIDE COVER LH (for LH Side) See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Installation
5. INSTALL FRONT UPPER FENDER PROTECTOR RH (for RH Side) See: Wiper and Washer Systems/Wiper Motor/Service and
Repair/Installation
6. INSTALL ENGINE ROOM SIDE COVER RH (for RH Side) See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Installation
7. INSTALL FRONT BUMPER ASSEMBLY See: Body and Frame/Bumper/Front Bumper/Service and Repair/Installation
