IS F V8-5.0L (2UR-GSE) (2008)
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: FRONT SPEED SENSOR: REMOVAL
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: FRONT SPEED SENSOR: REMOVAL
HINT:
-
Use the same procedure for the RH side and LH side.
-
The procedure listed below is for the LH side.
-
If the sensor rotor needs to be replaced, replace it together with the front axle hub sub-assembly with front speed sensor.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
2. REMOVE FRONT WHEEL
3. DISCONNECT FRONT SPEED SENSOR WIRE
(a) Disconnect the front speed sensor wire from the front speed sensor.
4. SEPARATE FRONT DISC BRAKE CYLINDER ASSEMBLY See: Steering and Suspension/Suspension/Suspension Strut / Shock
Absorber/Service and Repair/Front Shock Absorber/Removal
5. REMOVE FRONT DISC See: Brakes and Traction Control/Disc Brake System/Service and Repair/Front Brake/Removal
6. REMOVE FRONT AXLE HUB SUB-ASSEMBLY WITH FRONT SPEED SENSOR See: Maintenance/Wheels and Tires/Wheel Hub/Service
and Repair/Front Axle Hub/Removal
7. REMOVE FRONT SPEED SENSOR
(a) Install 3 hub nuts to the hub bolts. Hold the front axle hub sub-assembly in a vise between aluminum plates.
NOTICE: Replace the hub and bearing assembly if it is dropped or receives a strong shock.
(b) Using SST, remove the front speed sensor from the front axle hub sub-assembly.
SST: 09520-24010
SST: 09950-00020
SST: 09950-00030