IS F V8-5.0L (2UR-GSE) (2008)
(b) Disconnect the heated oxygen sensor connector.
(c) Remove the grommet.
(d) Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.
SST: 09224-00010
Installation
2UR-GSE ENGINE CONTROL: HEATED OXYGEN SENSOR: INSTALLATION
2UR-GSE ENGINE CONTROL: HEATED OXYGEN SENSOR: INSTALLATION
1. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
(a) Using SST, Install the heated oxygen sensor to the front exhaust pipe assembly.
SST: 09224-00010
without SST - Torque: 44 Nm (449 kgf-cm, 32 ft-lbf)
with SST - Torque: 40 Nm (408 kgf-cm, 30 ft-lbf)
NOTICE:
-
The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
-
The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) See: Service
Precautions.
-
The "with SST" torque value is effective when SST is parallel to the torque wrench.
(b) Install the grommet to the vehicle.