IS F V8-5.0L (2UR-GSE) (2008)
OK -- Continue to next step.
11. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Disconnect the park/neutral position switch connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(c) Reconnect the park/neutral position switch connector.
NG -- REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
OK -- Continue to next step.
12. CHECK HARNESS AND CONNECTOR (ST CUT RELAY POWER SOURCE)
(a) Remove the ST CUT relay from the engine room No. 2 relay block.
(b) Turn the engine switch on (IG).
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
(d) Reinstall the ST CUT relay.
NG -- CHECK HARNESS AND CONNECTOR (ST CUT RELAY - POWER SOURCE CONTROL ECU)
OK -- Continue to next step.
13. CHECK HARNESS AND CONNECTOR (ST CUT RELAY - BODY GROUND)