IS F V8-5.0L (2UR-GSE) (2008)
(b) Install 2 spacers (SST spacer B) as shown in the illustration.
SST: 09960-20010
09961-02060
09961-02060
A:
1 mm (0.0394 in.) or more
NOTICE: As SST may be damaged, make sure that the clearance between the arm and spacers is less than 1 mm (0.0394 in.).
(c) Using SST, separate the rear No. 2 upper control arm assembly from the rear axle carrier sub-assembly as shown in the illustration.
SST: 09960-20010
09961-02010
09961-02060
09961-02060
CAUTION: Apply grease to the threads and end of the SST bolt.
NOTICE:
-
Install SST so that A and B are parallel.
-
Be sure to place a wrench on the part indicated in the illustration.
-
Make sure that SST is securely positioned on the rear axle carrier.
-
Use caution not to damage the rear axle carrier sub-assembly because it is made of aluminum and may be damaged easily.
-
Do not damage the ball joint dust cover.
-
Make sure that the SST string is securely tied to the vehicle.
If the rear axle carrier spacer has come off, replace the rear axle carrier sub-assembly with a new one.
(d) Remove the bolt, nut, washer, and rear No. 2 upper control arm assembly.
HINT: Push the rear axle assembly downward.