IS F V8-5.0L (2UR-GSE) (2008)
(a) Remove the bolt and nut (B), and separate the rear stabilizer link assembly and the height control sensor link bracket.
(b) Remove the bolt (A) and nut, and separate the rear shock absorber with coil spring.
NOTICE: Turn the bolt while holding the nut.
(c) Remove the bolt and nut (C), and remove the rear No. 2 suspension arm assembly.
40. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY RH
HINT: Perform the same procedure as the LH side.
41. REMOVE REAR DRIVE SHAFT ASSEMBLY LH See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Removal
42. REMOVE REAR DRIVE SHAFT ASSEMBLY RH
HINT: Perform the same procedure as the LH side.
43. REMOVE HOLE SNAP RING (for LH Side) See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service
and Repair/Removal
44. REMOVE HOLE SNAP RING (for RH Side)
HINT: Perform the same procedure as the LH side.
45. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY
(a) Disengage the clamp and disconnect the connector.
(b) Remove the 2 bolts and rear height control sensor sub-assembly.
46. REMOVE REAR STABILIZER BAR See: Stabilizer Bar/Service and Repair/Rear Stabilizer Bar/Removal
47. REMOVE REAR SUSPENSION REAR LOWER MEMBER BRACE LH