IS F V8-5.0L (2UR-GSE) (2008)
Light Assembly/Installation
14. INSTALL NO. 2 LUGGAGE COMPARTMENT TRIM HOOK See: Lighting and Horns/Tail Lamp/Service and Repair/Rear Combination Light
Assembly/Installation
15. INSTALL ROPE HOOK See: Lighting and Horns/Tail Lamp/Service and Repair/Rear Combination Light Assembly/Installation
16. INSTALL NO. 2 ROOM LIGHT ASSEMBLY See: Lighting and Horns/Trunk Lamp/Service and Repair/Installation
17. INSTALL REAR LUGGAGE COMPARTMENT TRIM COVER See: Lighting and Horns/Tail Lamp/Service and Repair/Rear Combination
Light Assembly/Installation
18. INSTALL ROPE HOOK ASSEMBLY See: Lighting and Horns/Tail Lamp/Service and Repair/Rear Combination Light Assembly/Installation
19. INSTALL DECK SIDE TRIM BOX RH
20. INSTALL DECK SIDE TRIM BOX LH
21. INSTALL NO. 2 LUGGAGE COMPARTMENT TRIM COVER
22. INSPECT AND ADJUST REAR WHEEL ALIGNMENT See: Alignment/Service and Repair/Rear Wheel Alignment.
23. INSPECT AND ADJUST HEADLIGHT AIMING See: Lighting and Horns/Headlamp/Adjustments.
Disposal
REAR SUSPENSION: REAR SHOCK ABSORBER: DISPOSAL
REAR SUSPENSION: REAR SHOCK ABSORBER: DISPOSAL
1. DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY
(a) Fully extend the rear shock absorber rod.
(b) Using a drill, make a hole in the cylinder somewhere between A and B, as shown in the illustration, to discharge the gas inside.
CAUTION:
-
Be careful when drilling because shards of metal may fly about. Always use proper safety equipment.
-
The gas is colorless, odorless, and non-poisonous.