IS F V8-5.0L (2UR-GSE) (2008)
Control Module: Service and Repair
Installation
AA80E AUTOMATIC TRANSMISSION / TRANSAXLE: TCM: INSTALLATION
AA80E AUTOMATIC TRANSMISSION / TRANSAXLE: TCM: INSTALLATION
1. INSTALL TCM
(a) Install the TCM to the ECM box.
NOTICE: Install the TCM in the ECM box with the name plate facing the inside of the vehicle.
(b) Install the 2 nuts.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
NOTICE:
-
Make sure that the stud bolts are securely installed into the front and rear bolt holes.
-
Insert the stud bolt in the vehicle rear side to the TCM first.
(c) Connect the 8 connectors.
NOTICE: Be sure to securely connect the connector.
(d) Connect the connector holder.
2. INSTALL ENGINE ROOM ECU COVER See: Powertrain Management/Computers and Control Systems/Engine Control Module/Service and
Repair/Removal and Replacement/Installation
3. INSTALL ENGINE ROOM SIDE COVER LH See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation
4. INSTALL COOL AIR INTAKE DUCT SEAL See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
6. CHECK AUTOMATIC TRANSMISSION SYSTEM PRECAUTION
(a) After replacing the TCM, certain procedures are necessary See: Transmission Control Systems/Testing and Inspection/Programming and