IS F V8-5.0L (2UR-GSE) (2008)
Power Window Control Module: Technical Service Bulletins
Body - Power Window Initialization Procedure
PRE-DELIVERY SERVICE
PD073-07
Title:
INITIALIZATION OF POWER WINDOW
DURING PDS
Models:
'08 IS F
November 15, 2007
Introduction
Initialize the power window for each door after installing the DCC fuse during Pre-Delivery Service (PDS).
The installation of the DCC fuse, and the initialization procedure shown below, will enable the "one-touch open and close" and "jam protection"
functions for the power window of each door.
NOTE:
Any time the battery terminal has been disconnected, the power window for each door MUST be re-initialized.
Applicable Vehicles
^
2008 model year IS F vehicles.
Warranty Information
Initialization Procedure
1.
Push the engine switch to select the "IG-ON" mode.
At this time, the driver's door power window switch will blink.
2.
Push the driver's door power window switch and lower the window halfway