IS F V8-5.0L (2UR-GSE) (2008)
/Page-3047003.png)
(2) Check that the whole contact surface of the back window glass rim is perfectly even.
(3) Align the matchmarks on the back window glass and vehicle body.
NOTICE: Check that the back window glass stoppers are attached to the vehicle body correctly.
(4) Remove the back window glass assembly.
(b) Using a brush, coat the installation surface on the vehicle body with Primer M.
NOTICE:
-
Do not coat the adhesive with Primer M.
-
Do not apply too much primer.
-
Allow the primer coating to dry for 3 minutes or more.
-
Do not keep any of the opened Primer M for later use.
HINT: If an area other than specified is coated by accident, wipe off the primer with a clean piece of cloth before it dries.
(c) Using a brush or sponge, coat the adhesive application area with Primer G.
NOTICE:
-
Do not apply too much primer.
-
Allow the primer coating to dry for 3 minutes or more.
-
Do not keep any of the opened Primer G for later use.
HINT: If an area other than specified is coated by accident, wipe off the primer with a clean piece of cloth before it dries.
(d) Apply adhesive to the glass.
Adhesive:
Toyota Genuine Windshield Glass Adhesive or equivalent
(1) Cut off the tip of the cartridge nozzle as shown in the illustration.
HINT: After cutting off the tip, use all adhesive within the time described in the table below.
Usage Time Frame:
