LS 400 V8-4.0L (1UZ-FE) (1990)
Figure 1
2.
Remove the throttle linkage cover (2 bolts and 1 cap nut).
Figure 2
3.
Remove the clip that retains the end of the cruise control cable to the throttle linkage.
4.
Loosen the nut on the cable housing side of the mounting bracket and disconnect the cable.
Figure 3
3.
Remove the cruise control actuator cover.
Note:
Use care when pulling up on the cover to avoid damage to the cover and retaining clips.
6.
Disconnect the actuator electrical connector.
7.
Remove the actuator mounting bolts. (3 bolts)
8.
Remove the original actuator from the vehicle.
Cruise Control Actuator Installation
1.
Install the new cruise control actuator.