LS 400 V8-4.0L (1UZ-FE) (1990)
2.
Inspect the connection of alternator connector by following the chart shown below.
3.
Verification
1)
Turn the ignition switch on and check the battery indicator operation.
Ignition switch on:
Battery indicator light on
After starting engine:
Battery indicator light off
2)
Install the engine undercover.
Completion Label
IMPORTANT
^
After completing repair and before returning vehicle to the customer, the diagnostic specialist must verify that a SSC completion label is affixed to
the left fender inside panel, make sure that the surface is clean and dry to ensure proper adhesion of the label.
^
The label is to be filled out as follows:
^
Additional SSC completion labels (P/N 00410-01917) may be ordered through the non-parts system on a 1450 order form or through the TDN
system.