LS 400 V8-4.0L (1UZ-FE) (1990)
/Page-331004.png)
Remove the 4 bolts, timing belt cover and 3 gaskets.
17. Remove LH No.3 timing belt cover.
(a) Disconnect the vacuum hose from the EVAP BVSV.
(b) Remove the 4 bolts.
(c) Disconnect the cord grommet from the timing belt cover and 3 gaskets.
(d) Remove the cord grommet.
18. Remove high tension cords.
(a) Disconnect the 5 cord clamps together with the high tension cords from the lower high tension cord cover.
(b) Remove the 5 cord clamps from the high tension cords.
(c) (Ignition Coil Side) Disconnect the cord holder from the ignition coil.
(d) Disconnect the high tension cord by pulling the grommet, and remove the 10 high tension cords.
NOTICE: Pulling or bending the cords may damage the conductor inside.
19. Remove drive belt idler pulley.
