LS 400 V8-4.0L (1UZ-FE) (1990)
Install the brake cylinder to the rear axle carrier with the two bolts.
Torque: 104 N.m (1,065 kgf.cm, 77 ft.lbf)
7. CONNECT STABILIZER BAR LINKS
Connect the right and left stabilizer bar links to the stabilizer bar.
Torque: 35 N.m (360 kgf.cm, 26 ft. lbf)
8. STABILIZE SUSPENSION
(a) Install the rear wheel and jack down the vehicle.
NOTICE: Be careful of objects sticking out from the floor as the vehicle height is noticeably lower due to the air taken out of the
pneumatic cylinders.
(b) Move the height control ON/OFF switch to "ON".
(c) Start the engine and fill up the pneumatic cylinder with air.
(d) Bounce the vehicle up and down several times to stabilize the suspension.