LS 400 V8-4.0L (1UZ-FE) (1990)
9. TORQUE BOLT ON LOWER SIDE OF PNEUMATIC CYLINDER
(a) Jack up the vehicle and remove the rear wheel.
(b) Support the rear axle carrier with jack.
(c) Torque the bolt to the specified torque.
Torque: 137 N.m (1,400 kgf.cm, 101 ft.lbf)
10. INSTALL REAR WHEEL AND LOWER VEHICLE
Torque: 1,050 kg-cm (76 ft-lb, 103 Nm)
11. INSTALL FOLLOWING PARTS
(a) Install the luggage compartment trim.
(b) Install the package tray trim.
(c) Install the right and left roof side inner garnishes.
(d) Install the right and left rear scuff plates.
(e) Install the rear seat back and rear seat cushion.
12. CHECK REAR WHEEL ALIGNMENT See: Alignment/Service and Repair