LS 400 V8-4.0L (1UZ-FE) (1990)
5. CHECK BACKLASH IN BEARING SHAFT DIRECTION
Place the dial indicator near the center of the axle hub and check the backlash in the bearing shaft direction.
Maximum: 0.05 mm (0.0020 in.) If greater than the specified maximum, replace the bearing.
6. CHECK AXLE HUB DEVIATION
Using a dial indicator, check the deviation at the surface of the axle hub outside the hub bolt.
Maximum: 0.05 mm (0.0020 in.) If greater than the specified maximum, replace the axle hub.
7. LOOSEN AXLE SHAFT NUT
HINT: When removing the axle hub from the steering knuckle, loosen the nut before hand.
(a) Using a screwdriver, remove the grease cap from the steering knuckle.