LS 430 V8-4.3L (3UZ-FE) (2002)
into contact with each other when you remove the camshaft timing pulley (step 15), causing damage. So always set the crankshaft pulley at the
correct angle.
d. Remove the crankshaft pulley bolt.
NOTICE: Do not turn the crankshaft pulley.
TEMPORARILY INSTALL TIMING BELT
NOTICE: The engine should be cold.
a. Remove any oil or water on the crankshaft pulley, oil pump pulley, water pump pulley, No.1 idler pulley and No.2 idler pulley, and keep them
clean.
NOTICE: Only wipe the pulleys; do not use any cleansing agent.
b. Align the installation mark on the timing belt with the timing mark of the crankshaft timing pulley.
c. Install the timing belt on the crankshaft timing pulley, No.1 idler pulley and No.2 idler pulley.
TIMING BELT COVER SPACER
a. Install the gasket to the cover spacer.
b. Install the cover spacer.
TIMING BELT GUIDE
Install the belt guide, facing the cup side outward.
NO.1 TIMING BELT COVER
Install the timing belt cover with the 4 bolts.
CRANKSHAFT PULLEY
a. Align the pulley set key with the key groove of the crankshaft pulley.
b. Using SST and a hammer, tap in the crankshaft pulley.
SST 09223-406011