LS 430 V8-4.3L (3UZ-FE) (2002)
b. Remove the nut and anchor from the front seat.
6. REMOVE CENTER PILLAR LOWER GARNISH
Using a screwdriver, remove the center pillar lower garnish.
HINT: Tape the screwdriver tip before use.
7. REMOVE CENTER PILLAR UPPER GARNISH
a. Remove the 2 screws.
b. Using a screwdriver, remove the center pillar upper garnish.
HINT: Tape the screwdriver tip before use.
8. REMOVE FRONT SEAT OUTER BELT
CAUTION: Never disassemble the front seat outer belt.
NOTE: When removing the retractor of front seat outer belt, take care not to pull the seat belt pretensioner wire harness.
a. Remove the nut and front seat outer belt shoulder anchor.
b. Disconnect the connector.
c. Disconnect the pretensioner connector as shown in the illustration.
CAUTION: When removing the seat belt pretensioner, work must be started 90 seconds after the ignition switch is turned to the "LOCK"
position and the negative (-) terminal cable is disconnected from the battery.
d. Remove the 2 bolts and retractor of front seat outer belt.