LS 460 V8-4.6L (1UR-FSE) (2007)
5. INSTALL NO.3 BRAKE ACTUATOR TUBE
NOTE:
-
Do not damage the No.3 brake actuator tube, brake actuator and brake accumulator pump.
-
When installing the No.3 brake actuator tube, hold the tube, brake actuator and brake accumulator pump securely.
-
When tightening the nut, make sure that other parts do not move with the nut.
a. Using SST, connect the No. 3 brake actuator tube.
SST 09023-00101
Torque:
15 N.m (155 kgf.cm, 11 ft.lbf) without SST
14 N.m (145 kgf.cm, 10 ft.lbf) with SST
HINT:
-
Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
-
This torque value is effective when SST is parallel to a torque wrench.
6. INSTALL NO.2 BRAKE ACTUATOR HOSE
NOTE: Do not remove the cap installed to the reservoir connector until it is connected to the reservoir.