LS 460 V8-4.6L (1UR-FSE) (2007)
d. Operate the intelligent tester or Techstream according to the display and select "DATA LIST".
e. Depress the brake pedal 4 or 5 times to operate the pump motor, and check the output value on the intelligent tester or Techstream with the
motor stopped (not braking).
OK: Accumulator pressure sensor's output voltage drops 0.2 V or less for 30 seconds.
If the voltage drops more than 0.2 V, there may be a brake fluid leak from the No. 3 brake actuator tube connection area. Remove the brake
actuator and brake accumulator pump, and then repeat the procedures from the retightening of the 2 union nuts of the No. 3 brake actuator tube
SST 09023-00101
Torque:
15 N.m (155 kgf.cm, 11 ft.lbf) without SST
14 N.m (145 kgf.cm, 10 ft.lbf) with SST
HINT:
-
Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
-
This torque value is effective when SST is parallel to a torque wrench.
40. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
41. INSTALL COWL TOP VENTILATOR LOUVER PROTECTOR LH
42. INSTALL FENDER TO COWL SIDE SEAL LH
43. INSTALL FRONT FENDER TO COWL SIDE SEAL RH
44. INSTALL HOOD TO COWL TOP SEAL
45. INSTALL FRONT FENDER PROTECTOR UPPER LH
46. INSTALL FRONT FENDER PROTECTOR UPPER RH
47. INSTALL ENGINE ROOM SIDE COVER RH
48. INSTALL ENGINE ROOM SIDE COVER LH
49. INSTALL FRONT WIPER ARM LH
50. INSTALL FRONT WIPER ARM RH
51. INSTALL COWL TOP VENTILATOR LOUVER RH
52. INSTALL V-BANK COVER SUB-ASSEMBLY