LS 460 V8-4.6L (1UR-FSE) (2007)
b. Using a brush or felt, apply primer or equivalent to the retainer installation area.
NOTE:
-
Use a clean brush or felt.
-
Do not allow primer to contact the front surface of the bumper cover.
-
A thin layer of primer will be left behind if it is applied on painted surfaces so apply to protect the painted surface.
-
Do not touch surfaces where primer has been applied until tape has been applied.
c. Do not touch the bumper cover until the primer has dried.
Recommended drying time: 10 minutes or more {23 degrees C, (73 degrees F)}
d. Confirm that the primer has completely dried by touching the bumper cover.
Then remove the protective tape.
7. INSTALL THE ULTRASONIC SENSOR RETAINER