LS 460 V8-4.6L (1UR-FSE) (2007)
a. Connect the connector (labeled A) to the rear speed sensor.
b. Install the sensor clamp (labeled B) with the bolt (labeled C).
Torque: 8.5 N.m (87 kgf.cm, 75 in.lbf)
NOTE: Do not twist the sensor wire when installing the clamps.
c. for RH:
Connect the pad wear indicator connector (labeled D).
d. Install the sensor clamp (labeled E) with the nut (labeled F).
Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)
NOTE: Do not twist the sensor wire when installing the clamps.
e. Except for RH side of models with coil spring type suspension:
1. Install the sensor clamp (labeled G) with the nut (labeled H).
Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)
2. Connect the rear height control sensor connector (labeled I).