LS 460 V8-4.6L (1UR-FSE) (2007)
b. Remove the 2 screws and end frame.
NOTE: While holding down the lead wire, remove the start commutator end frame.
4. REMOVE STARTER ARMATURE ASSEMBLY
a. Using a screwdriver, hold the spring back and disconnect the brush from the brush holder.
b. Disconnect the 4 brushes, and remove the brush holder.
c. Remove the starter armature from the yoke.
5. REMOVE STARTER YOKE ASSEMBLY
a. Remove the starter yoke from the starter center bearing clutch sub-assembly.
6. REMOVE STARTER ARMATURE PLATE
a. Remove the armature plate from the center bearing clutch sub-assembly.