LS 460 V8-4.6L (1UR-FSE) (2007)
4. INSPECT REAR AXLE HUB BEARING LOOSENESS
(a)
Using a dial indicator, check for looseness near the center of the axle hub.
Maximum: 0.05 mm (0.0020 in.)
NOTICE: Ensure that the dial indicator is set at a right angle to the measurement surface.
If the looseness exceeds the maximum, replace the axle hub.
5. INSPECT REAR AXLE HUB RUNOUT
(a)
Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
Maximum: 0.05 mm (0.0020 in.)
NOTICE: Ensure that the dial indicator is set at a right angle to the measurement surface.
If the runout exceeds the maximum, replace the axle hub.
6. INSTALL REAR DISC
7. ADJUST PARKING BRAKE SHOE CLEARANCE
8. CONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH
9. INSTALL REAR WHEEL
Torque: 140 N*m (1428 kgf*cm, 103 ft.*lbf)
REMOVAL
HINT:
^
Use the same procedures for the RH side and LH side.
^
The procedures listed below are for the LH side.
1. REMOVE REAR WHEEL