LS 460 V8-4.6L (1UR-FSE) (2007)
NOTICE:
^
Make sure to install the spacers (SST spacer B) as the steering knuckle spacer may shift.
^
As SST may become damaged, make sure the space between the arm and spacers is not 1 mm or less.
(f)
Using SST, disconnect the front No. 2 suspension upper arm from the steering knuckle.
SST 09960-20010 (09961-02010)
NOTICE:
^
Do not damage the dust cover.
^
As the dust cover may be damaged, adjust SST with the center nut so that the body and crow are parallel.
^
Make sure to tie the string of SST to the vehicle to prevent SST from dropping.
13. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH
(a)
Remove the 4 bolts and front axle hub from the steering knuckle.
INSTALLATION
HINT:
^
Use the same procedures for the RH side and LH side.
^
The procedures listed below are for the LH side.
^
A bolt without a torque specification is shown in the standard bolt chart.
1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH